如何使用命令行创建交换分区gparted
?(parted)
我已成功创建分区,但似乎无法将分区设置为Linux swap / Solaris
。我试过
mkpart extended linux-swap -512MB -1s
// -> Error: Invalid number.
&
mkpart extended linux-swap(v1) -512MB -1s
// -> Error: Invalid number.
&
mkpart
type: extended
Start: -512MB
End: -1s
// this works, but I can't set the FS-TYPE
// 帮助页面
(parted) help mkpart
mkpart PART-TYPE [FS-TYPE] START END make a partition
PART-TYPE is one of: primary, logical, extended
FS-TYPE is one of: zfs, btrfs, nilfs2, ext4, ext3, ext2, fat32, fat16, hfsx, hfs+, hfs, jfs, swsusp, linux-swap(v1), linux-swap(v0), ntfs,
reiserfs, freebsd-ufs, hp-ufs, sun-ufs, xfs, apfs2, apfs1, asfs, amufs5, amufs4, amufs3, amufs2, amufs1, amufs0, amufs, affs7, affs6, affs5,
affs4, affs3, affs2, affs1, affs0, linux-swap, linux-swap(new), linux-swap(old)
START and END are disk locations, such as 4GB or 10%. Negative values count from the end of the disk. For example, -1s specifies exactly the
last sector.
'mkpart' makes a partition without creating a new file system on the partition. FS-TYPE may be specified to set an appropriate partition ID.
答案1
假设您parted
在/dev/sda
磁盘设备上使用,并且已经在上创建了主 ext4 分区/dev/sda2
$ sudo parted /dev/sda
(parted) mkpart
Partition type? primary/extended? primary
File system type? [ext2]? linux-swap
Start? 0%
End? 100%
然后你需要格式化交换文件系统并打开它
$ sudo mkswap /dev/vdb2
$ sudo swapon --all --verbose
swapon on /dev/sda2
swapon: /dev/sda2: found swap signature: version 1, page-size 4, same byte order
swapon: /dev/sda2: pagesize=4096, swapsize=2147483648, devsize=2147483648
将其添加/etc/fstab
以便每次重启时都会安装它。
$ sudo vi /etc/fstab
/dev/sda2 none swap sw 0 0
答案2
如果您已经创建了分区,我认为您可以使用“mkswap”而不是“mkpart”。