Kubuntu 中 wifi 或以太网连接的下载或上传速度为 0

Kubuntu 中 wifi 或以太网连接的下载或上传速度为 0

我正在试用 Kubuntu 22.10 几个星期。之前它运行良好,但从前天开始,我建立的任何网络连接都没有下载或上传速度。我已经排除了任何硬件或路由器问题,因为同一设备中的 Ubuntu 系统运行完全正常。(我有双启动设置)。我尝试浏览论坛,但没有找到任何对我有用的方法。我尝试禁用防火墙,但也没有用。它可以连接到路由器管理员页面,但无法连接到任何其他页面。
我不知道这是否有帮助,但这是lshw -c Network

*-network
       description: Wireless interface
       product: RTL8821CE 802.11ac PCIe Wireless Network Adapter
       vendor: Realtek Semiconductor Co., Ltd.
       physical id: 0
       bus info: pci@0000:02:00.0
       logical name: wlp2s0
       version: 00
       serial: 28:39:26:25:64:ef
       width: 64 bits
       clock: 33MHz
       capabilities: pm msi pciexpress bus_master cap_list ethernet physical wireless
       configuration: broadcast=yes driver=rtw_8821ce driverversion=5.19.0-28-generic firmware=N/A ip=192.168.1.102 latency=0 link=yes multicast=yes wireless=IEEE 802.11
       resources: irq:141 ioport:4000(size=256) memory:a4300000-a430ffff
  *-network
       description: Ethernet interface
       product: RTL8111/8168/8411 PCI Express Gigabit Ethernet Controller
       vendor: Realtek Semiconductor Co., Ltd.
       physical id: 0
       bus info: pci@0000:03:00.0
       logical name: enp3s0
       version: 10
       serial: e8:6a:64:e1:db:e1
       capacity: 1Gbit/s
       width: 64 bits
       clock: 33MHz
       capabilities: pm msi pciexpress msix vpd bus_master cap_list ethernet physical tp mii 10bt 10bt-fd 100bt 100bt-fd 1000bt-fd autonegotiation
       configuration: autonegotiation=on broadcast=yes driver=r8169 driverversion=5.19.0-28-generic firmware=rtl8168g-3_0.0.1 04/23/13 latency=0 link=no multicast=yes port=twisted pair
       resources: irq:17 ioport:3000(size=256) memory:a4204000-a4204fff memory:a4200000-a4203fff   

这是输出iwconfig

lo        no wireless extensions.

enp3s0    no wireless extensions.

wlp2s0    IEEE 802.11  ESSID:"Shitdroid"
          Mode:Managed  Frequency:2.462 GHz  Access Point: 58:D9:D5:53:A8:D8
          Bit Rate=39 Mb/s   Tx-Power=20 dBm
          Retry short limit:7   RTS thr:off   Fragment thr:off
          Encryption key:off
          Power Management:off
          Link Quality=70/70  Signal level=-24 dBm
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:7   Missed beacon:0

lxcbr0    no wireless extensions.

这是输出 ifconfig

enp3s0: flags=4099<UP,BROADCAST,MULTICAST>  mtu 1500
        ether e8:6a:64:e1:db:e1  txqueuelen 1000  (Ethernet)
        RX packets 0  bytes 0 (0.0 B)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 0  bytes 0 (0.0 B)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0

lo: flags=73<UP,LOOPBACK,RUNNING>  mtu 65536
        inet 127.0.0.1  netmask 255.0.0.0
        inet6 ::1  prefixlen 128  scopeid 0x10<host>
        loop  txqueuelen 1000  (Local Loopback)
        RX packets 51208  bytes 4477590 (4.4 MB)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 51208  bytes 4477590 (4.4 MB)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0

lxcbr0: flags=4099<UP,BROADCAST,MULTICAST>  mtu 1500
        inet 10.0.3.1  netmask 255.255.255.0  broadcast 10.0.3.255
        ether 00:16:3e:00:00:00  txqueuelen 1000  (Ethernet)
        RX packets 0  bytes 0 (0.0 B)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 0  bytes 0 (0.0 B)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0

wlp2s0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST>  mtu 1500
        inet 192.168.0.100  netmask 255.255.255.0  broadcast 192.168.0.255
        inet6 fe80::2a39:26ff:fe25:64ef  prefixlen 64  scopeid 0x20<link>
        ether 28:39:26:25:64:ef  txqueuelen 1000  (Ethernet)
        RX packets 27  bytes 3374 (3.3 KB)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 61  bytes 13406 (13.4 KB)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0

这是输出route

Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
default         192.168.0.1     0.0.0.0         UG    600    0        0 wlp2s0
10.0.3.0        0.0.0.0         255.255.255.0   U     0      0        0 lxcbr0
link-local      0.0.0.0         255.255.0.0     U     1000   0        0 lxcbr0
192.168.0.0     0.0.0.0         255.255.255.0   U     600    0        0 wlp2s0

所有输出都是在连接到 wifi 时获取的。我已检查了驱动程序lsmod,驱动程序rtw88_8821ce出现在列表中。如果这是一个新手问题,我很抱歉,但任何帮助都将不胜感激。

相关内容