在 Ubuntu 安装与 Windows 双启动时不显示硬盘

在 Ubuntu 安装与 Windows 双启动时不显示硬盘

我正在尝试双启动我的 Windows 笔记本电脑和 Ubuntu。我对硬盘进行了如下分区: 在此处输入图片描述 我为 Ubuntu 分配了未分配的 100GB。

我使用 Etcher 用 Ubuntu .iso 文件设置了我的 USB。然后我就可以从闪存驱动器启动我的系统了。但是,当我在笔记本电脑上安装 Ubuntu 时,硬盘驱动器没有出现,只有闪存驱动器。 在此处输入图片描述

我尝试单击“新建分区表”,但并没有太大变化: 在此处输入图片描述

我需要做什么才能使我创建的硬盘分区可访问,以便可以在硬盘上安装 Ubuntu?


编辑:

ubuntu@ubuntu:~$ sudo lsblk -f
NAME   FSTYPE  LABEL             UUID                                 MOUNTPOINT
loop0  squashf                                                        /rofs
sda    iso9660 Ubuntu 16.04.3 LTS amd64
│                                2017-08-01-11-51-33-00               /cdrom
├─sda2 vfat    Ubuntu 16.04.3 LTS amd64
│                                398E-230F                            
└─sda1 iso9660 Ubuntu 16.04.3 LTS amd64
                                 2017-08-01-11-51-33-00       


ubuntu@ubuntu:~$ sudo parted -l
Warning: The driver descriptor says the physical block size is 2048 bytes, but
Linux says it is 512 bytes.
Ignore/Cancel?


ubuntu@ubuntu:~$ lspci
00:00.0 Host bridge: Intel Corporation Device 5904 (rev 02)
00:02.0 VGA compatible controller: Intel Corporation Device 5916 (rev 02)
00:04.0 Signal processing controller: Intel Corporation Skylake Processor Thermal Subsystem (rev 02)
00:14.0 USB controller: Intel Corporation Sunrise Point-LP USB 3.0 xHCI Controller (rev 21)
00:14.2 Signal processing controller: Intel Corporation Sunrise Point-LP Thermal subsystem (rev 21)
00:15.0 Signal processing controller: Intel Corporation Sunrise Point-LP Serial IO I2C Controller (rev 21)
00:15.1 Signal processing controller: Intel Corporation Sunrise Point-LP Serial IO I2C Controller (rev 21)
00:15.2 Signal processing controller: Intel Corporation Sunrise Point-LP Serial IO I2C Controller (rev 21)
00:16.0 Communication controller: Intel Corporation Sunrise Point-LP CSME HECI (rev 21)
00:17.0 RAID bus controller: Intel Corporation 82801 Mobile SATA Controller [RAID mode] (rev 21)
00:1c.0 PCI bridge: Intel Corporation Device 9d10 (rev f1)
00:1c.2 PCI bridge: Intel Corporation Device 9d12 (rev f1)
00:1d.0 PCI bridge: Intel Corporation Device 9d18 (rev f1)
00:1e.0 Signal processing controller: Intel Corporation Sunrise Point-LP Serial IO UART Controller (rev 21)
00:1f.0 ISA bridge: Intel Corporation Device 9d4e (rev 21)
00:1f.2 Memory controller: Intel Corporation Sunrise Point-LP PMC (rev 21)
00:1f.3 Audio device: Intel Corporation Device 9d71 (rev 21)
00:1f.4 SMBus: Intel Corporation Sunrise Point-LP SMBus (rev 21)
3a:00.0 Network controller: Intel Corporation Device 24fd (rev 78)
3b:00.0 3D controller: NVIDIA Corporation GM108M [GeForce 940MX] (rev a2)



ubuntu@ubuntu:~$ sudo lshw -C storage
  *-usb:0                 
       description: Mass storage device
       product: Cruzer Fit
       vendor: SanDisk
       physical id: 3
       bus info: usb@1:3
       logical name: scsi8
       version: 1.00
       serial: 4C530202001107123400
       capabilities: usb-2.10 scsi emulated scsi-host
       configuration: driver=usb-storage maxpower=224mA speed=480Mbit/s
  *-storage
       description: RAID bus controller
       product: 82801 Mobile SATA Controller [RAID mode]
       vendor: Intel Corporation
       physical id: 17
       bus info: pci@0000:00:17.0
       version: 21
       width: 32 bits
       clock: 66MHz
       capabilities: storage msix pm bus_master cap_list
       configuration: driver=ahci latency=0
       resources: irq:16 memory:93190000-93197fff memory:9319c000-9319c0ff ioport:4080(size=8) ioport:4088(size=4) ioport:4060(size=32) memory:93100000-9317ffff

相关内容