我使用的是 Ubuntu 16.04，并且安装了带有 Intel 82575 芯片组的 PCI 双网卡。该卡已被识别，并且已分配给它的 igb 驱动程序，但只有一个接口变为活动状态。
如何配置驱动程序以识别这两个接口？
02:00.0 Ethernet controller: Intel Corporation 82575EB Gigabit Network Connection (rev 02)
02:00.1 Ethernet controller: Intel Corporation 82575EB Gigabit Network Connection (rev 02)
ethtool -i enp2s0f1
driver: igb
version: 5.4.0-k
firmware-version: 1.115, 0x87850000
expansion-rom-version:
bus-info: 0000:02:00.1
supports-statistics: yes
supports-test: yes
supports-eeprom-access: yes
supports-register-dump: yes
supports-priv-flags: yes
ip link show
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN mode DEFAULT group default qlen 1000
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
2: enp1s0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc pfifo_fast state DOWN mode DEFAULT group default qlen 1000
link/ether e0:d5:5e:b1:12:4f brd ff:ff:ff:ff:ff:ff
3: enp2s0f0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1520 qdisc mq master br0 state DOWN mode DEFAULT group default qlen 1000
link/ether 6c:b3:11:32:3e:d4 brd ff:ff:ff:ff:ff:ff
4: enp2s0f1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1520 qdisc mq master br0 state UP mode DEFAULT group default qlen 1000
link/ether 6c:b3:11:32:3e:d5 brd ff:ff:ff:ff:ff:ff
5: br0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1520 qdisc noqueue state UP mode DEFAULT group default qlen 1000
link/ether 6c:b3:11:32:3e:d4 brd ff:ff:ff:ff:ff:ff
任何有关故障排除位置的建议将不胜感激。谢谢。