☰

airodump-ng 不显示结果

tag-icon • tag-icon kali-linux airmon-ng aircrack-ng airodump-ng
airodump-ng 不显示结果

当我跑去 airodump-ng扫描周围的 Wi-Fi 时，我没有任何输出，就像我周围什么都没有一样。

我有一个集成在我的笔记本电脑 (Dell Inspiron 15) 中的 Qualcomm Atheros QCA9377 适配器​​，并且我运行的是 Kali Linux 64 2019.1

这是airmon-ng 的输出：

airmon-ng start wlan0

Found 3 processes that could cause trouble.
Kill them using 'airmon-ng check kill' before putting
the card in monitor mode, they will interfere by changing channels
and sometimes putting the interface back in managed mode

  PID Name
  550 NetworkManager
  602 wpa_supplicant
 2069 dhclient

PHY Interface   Driver      Chipset

phy0    wlan0       ath10k_pci  Qualcomm Atheros QCA9377 802.11ac Wireless Network Adapter (rev 31)

        (mac80211 monitor mode vif enabled for [phy0]wlan0 on [phy0]wlan0mon)
        (mac80211 station mode vif disabled for [phy0]wlan0)

我已经尝试过airmon-ng check kill，但没有成功，当我运行时airodump-ng，这就是我得到的：

CH 12 ][ Elapsed: 12 s ][ 2019-05-09 19:23                                    

 BSSID              PWR  Beacons    #Data, #/s  CH  MB   ENC  CIPHER AUTH ESSID


 BSSID              STATION            PWR   Rate    Lost    Frames  Probe

通过通道切换，我尝试使用 1 个特定通道，但我发现也没有使用此解决方案的端口。当我启动 linux 时，我还注意到一些与网络驱动程序相关的错误消息：

ath10k_pci 0000:02:00.0: firmware: failed to load ath10k/pre-cal-pci-0000:02:00.0.bin (-2)
firmware_class: See http://wiki.debian.org/Firmware for information about missing firmware
ath10k_pci 0000:02:00.0: firmware: failed to load ath10k/cal-pci-0000:02:00.0.bin(-2)
ath10k_pci 0000:02:00.0: firmware: failed to load ath10/QCA9377/hw1.0/firmware-6.bin (-2)

我还确认我的网络适配器支持监控模式，iw list并且监控模式出现在列表中：

Supported interface modes:
         * IBSS
         * managed
         * AP
         * monitor
         * mesh point
         * P2P-client
         * P2P-GO
         * P2P-device

相关内容