☰

这个RJ45连接器采用的是什么标准？

tag-icon • tag-icon networking ethernet
这个RJ45连接器采用的是什么标准？

我原本以为会看到 T568A/B，但两者都不是。这是什么？它是 1. 棕色 2. 绿色条纹 3. 橙色条纹 4. 蓝色 5. 蓝色条纹 6. 橙色 7. 绿色 8. 棕色条纹。我已将电线从墙里出来的另一侧连接到 T568B，但我的电线测试仪显示的却是这个。

前 4 个引脚 电线测试仪结果 最后 4 个图钉

编辑：

更新 根据这篇文章的评论，我相信这最初是为电话线设计的。我将顶部端口的接线切换为 T568A，并将其从另一侧墙壁出来的接线切换为 T568A。现在我的接线工​​具显示了这一点，但我仍然无法连接到以太网。我在 Windows 和 Linux PC 上都不断收到连接/断开错误。

在此处输入图片描述

编辑： 更新

是否配置

enp3s0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST>  mtu 1500
        inet6 fe80::ceeb:e1d3:c921:a67  prefixlen 64  scopeid 0x20<link>
        ether d8:5e:d3:d5:c5:d6  txqueuelen 1000  (Ethernet)
        RX packets 115  bytes 11018 (11.0 KB)
        RX errors 317  dropped 2  overruns 0  frame 317
        TX packets 519  bytes 77177 (77.1 KB)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 327
        device memory 0x53200000-532fffff

journalctl -u 网络管理器

May 29 02:28:29 mint-pc NetworkManager[842]: <info>  [1685341709.2321] device (enp3s0): state change: ip-config -> unavailable (reason 'carrier-changed', sys-iface-state: '>
May 29 02:28:29 mint-pc NetworkManager[842]: <info>  [1685341709.2584] dhcp4 (enp3s0): canceled DHCP transaction
May 29 02:28:56 mint-pc NetworkManager[842]: <info>  [1685341736.1757] device (enp3s0): carrier: link connected
May 29 02:28:56 mint-pc NetworkManager[842]: <info>  [1685341736.1761] device (enp3s0): state change: unavailable -> disconnected (reason 'carrier-changed', sys-iface-state>
May 29 02:28:56 mint-pc NetworkManager[842]: <info>  [1685341736.1773] policy: auto-activating connection 'Wired connection 1' (e66e6c53-8fde-3a56-b3bb-57ee5f0f0c8c)
May 29 02:28:56 mint-pc NetworkManager[842]: <info>  [1685341736.1782] device (enp3s0): Activation: starting connection 'Wired connection 1' (e66e6c53-8fde-3a56-b3bb-57ee5f>
May 29 02:28:56 mint-pc NetworkManager[842]: <info>  [1685341736.1785] device (enp3s0): state change: disconnected -> prepare (reason 'none', sys-iface-state: 'managed')
May 29 02:28:56 mint-pc NetworkManager[842]: <info>  [1685341736.2622] device (enp3s0): state change: prepare -> config (reason 'none', sys-iface-state: 'managed')
May 29 02:28:56 mint-pc NetworkManager[842]: <info>  [1685341736.2627] device (enp3s0): state change: config -> ip-config (reason 'none', sys-iface-state: 'managed')
May 29 02:28:56 mint-pc NetworkManager[842]: <info>  [1685341736.2630] dhcp4 (enp3s0): activation: beginning transaction (timeout in 45 seconds)
May 29 02:28:58 mint-pc NetworkManager[842]: <info>  [1685341738.8633] device (enp3s0): carrier: link connected
May 29 02:29:08 mint-pc NetworkManager[842]: <info>  [1685341748.4998] device (enp3s0): state change: ip-config -> unavailable (reason 'carrier-changed', sys-iface-state: '>
May 29 02:29:08 mint-pc NetworkManager[842]: <info>  [1685341748.5265] dhcp4 (enp3s0): canceled DHCP transaction

ethtool enp3s0

Settings for enp3s0:
    Supported ports: [  ]
    Supported link modes:   10baseT/Half 10baseT/Full
                            100baseT/Half 100baseT/Full
                            1000baseT/Full
                            2500baseT/Full
    Supported pause frame use: Symmetric
    Supports auto-negotiation: Yes
    Supported FEC modes: Not reported
    Advertised link modes:  10baseT/Half 10baseT/Full
                            100baseT/Half 100baseT/Full
                            1000baseT/Full
                            2500baseT/Full
    Advertised pause frame use: Symmetric
    Advertised auto-negotiation: Yes
    Advertised FEC modes: Not reported
    Speed: Unknown!
    Duplex: Unknown! (255)
    Auto-negotiation: on
    Port: Twisted Pair
    PHYAD: 0
    Transceiver: internal
    MDI-X: off (auto)
netlink error: Operation not permitted
        Current message level: 0x00000007 (7)
                               drv probe link
    Link detected: no

编辑：这是插在墙上的东西https://www.leviton.com/en/products/41108-rw8

相关内容