这是的延续另一个帖子现在已经解决了。
现在我实际上正在努力获取可用的无线网络列表。 Intel 7260 似乎已正确安装和检测,但任何加入名为“mar”的 ESSID 的尝试都会失败。我尝试过使用wpa_supplicant
(请参阅问题描述中的进一步内容)。
请注意,我可以获得使用的网络列表,iwlist scan
但没有使用结果wpa_cli list_networks
(请参阅进一步)。这对我来说没有多大意义,因为这对我来说都是新鲜事。
环境
- 下一个计算单元 NUC DC3217IYE
- 与 Debian 3.16-0.bpo.2-amd64
- 867Mbps 802.11ac Intel 7260 卡,双频 5GHz + 2.4GHz 无线 2x2 AC + 蓝牙4.0
消息
root@marvin:~# dmesg | grep wifi
[ 2.793592] iwlwifi 0000:02:00.0: enabling device (0000 -> 0002)
[ 2.793814] iwlwifi 0000:02:00.0: irq 44 for MSI/MSI-X
[ 2.801067] iwlwifi 0000:02:00.0: firmware: direct-loading firmware iwlwifi-7260-9.ucode
[ 2.801353] iwlwifi 0000:02:00.0: loaded firmware version 25.222.9.0 op_mode iwlmvm
[ 2.816828] iwlwifi 0000:02:00.0: Detected Intel(R) Dual Band Wireless AC 7260, REV=0x144
[ 2.817506] iwlwifi 0000:02:00.0: L1 Disabled; Enabling L0S
[ 2.817768] iwlwifi 0000:02:00.0: L1 Disabled; Enabling L0S
[ 4.697179] iwlwifi 0000:02:00.0: L1 Disabled; Enabling L0S
[ 4.697409] iwlwifi 0000:02:00.0: L1 Disabled; Enabling L0S
配置文件
# iwconfig
eth0 no wireless extensions.
wlan0 IEEE 802.11abgn ESSID:off/any
Mode:Managed Access Point: Not-Associated Tx-Power=0 dBm
Retry short limit:7 RTS thr:off Fragment thr:off
Encryption key:off
Power Management:on
lo no wireless extensions.
列表
$ sudo iwlist wlan0 scan
wlan0 Scan completed :
Cell 01 - Address: F4:CA:E5:FE:60:D4
Channel:10
Frequency:2.457 GHz (Channel 10)
Quality=29/70 Signal level=-81 dBm
Encryption key:on
ESSID:"mar"
Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 11 Mb/s; 22 Mb/s
6 Mb/s; 9 Mb/s; 12 Mb/s
Bit Rates:18 Mb/s; 24 Mb/s; 36 Mb/s; 48 Mb/s; 54 Mb/s
Mode:Master
Extra:tsf=0000001c32228160
Extra: Last beacon: 3276ms ago
IE: Unknown: 00036D6172
IE: Unknown: 010882848B962C0C1218
IE: Unknown: 03010A
IE: Unknown: 050400020000
IE: Unknown: 2A0104
IE: Unknown: 3205243048606C
IE: Unknown: 7F080000000000000040
IE: Unknown: DD180050F2020101000003A4000027A4000042435E0062322F00
Cell 02 - Address: F4:CA:E5:FE:60:D5
Channel:10
Frequency:2.457 GHz (Channel 10)
Quality=29/70 Signal level=-81 dBm
Encryption key:off
ESSID:"FreeWifi"
Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 11 Mb/s; 22 Mb/s
6 Mb/s; 9 Mb/s; 12 Mb/s
Bit Rates:18 Mb/s; 24 Mb/s; 36 Mb/s; 48 Mb/s; 54 Mb/s
Mode:Master
Extra:tsf=0000001c32228160
Extra: Last beacon: 3240ms ago
IE: Unknown: 00084672656557696669
IE: Unknown: 010882848B962C0C1218
IE: Unknown: 03010A
IE: Unknown: 050401020000
IE: Unknown: 2A0104
IE: Unknown: 3205243048606C
IE: Unknown: 2D1A6C0003FFFFFF0001000000000000000100000000000000000000
IE: Unknown: 3D160A001300000000000000000000000000000000000000
IE: Unknown: 7F080000000000000040
IE: Unknown: DD180050F2020101000003A4000027A4000042435E0062322F00
ip链接
# ip link show wlan0
3: wlan0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc mq state DOWN mode DORMANT qlen 1000
link/ether 00:15:00:bc:79:e2 brd ff:ff:ff:ff:ff:ff
接口
# more /etc/network/interfaces
# This file describes the network interfaces available on your system
# and how to activate them. For more information, see interfaces(5).
# The loopback network interface
#auto lo
#iface lo inet loopback
auto wlan0
iface wlan0 inet dhcp
wpa-conf /etc/wpa_supplicant/wpa_supplicant.conf
wpa_supplicant.conf
# more /etc/wpa_supplicant/wpa_supplicant.conf
network={
ssid="mar"
key_mgmt=NONE
wep_key0=fffffffff
}
# wpa_cli reconfigure
Selected interface 'wlan0'
FAIL
但最令人惊讶的是,而iwlist scan
提供了一个网络列表?
# wpa_cli list_networks
Selected interface 'wlan0'
network id / ssid / bssid / flags
# wpa_cli status
Selected interface 'wlan0'
wpa_state=INACTIVE
address=00:15:00:bc:79:e2
更新
# ps -ef | grep wpa
/sbin/wpa_supplicant -s -B -P /var/run/wpa_supplicant.wlan0.pid -i wlan0 -D nl80211,wext -t -ddd -c /etc/wpa_supplicant/wpa_supplicant.conf -C /var/run/wpa_supplicant
# wpa_cli scan_results
Selected interface 'wlan0'
bssid / frequency / signal level / flags / ssid
f4:ca:e5:fe:60:d4 2457 -83 [WEP][ESS] mar
f4:ca:e5:fe:60:d6 2457 -85 [WPA2-EAP-TKIP+CCMP][ESS] FreeWifi_secure
f4:ca:e5:fe:60:d5 2457 -83 [ESS] FreeWifi
但我仍然不太确定为什么list_networks
没有返回结果(?)我一定是误解了用法。