我正在运行 OpenIndiana (oi_151a8)，并且有两个使用 LACP 聚合的 NIC 连接到 Cisco WS-C3560G-48TS。服务器和交换机都显示聚合链路处于开启状态。但是，虽然链路层流量可见（“snoop”显示 ARP 请求等），但我无法传递任何 IP 流量（ping、ssh 均失败）。真正奇怪的是，聚合链路可以获取 DHCP 地址，该地址提供正确的网关、名称服务器等。我最初的想法是 VLAN 配置存在问题，但交换机在 VLAN1 上运行一切。我也尝试在两端明确添加它，但没有成功（OI 不允许我使用本机 VLAN 配置 VLAN）。有什么想法吗？
服务器上的配置
svcadm disable network/physical:nwam
svcadm enable network/physical:default
dladm create-aggr -l e1000g0 -l e1000g1 aggr1
ipadm create-addr -T DHCP aggr1/v4
dladm modify-aggr -L active -T long aggr1
服务器验证 （必须进行 OCR，因此部分文本被损坏）
admin@arc01:~# dladm show-link
LINK CLASS MTU STATE BRIDGE OVER
e1000g0 phys 1500 up -- --
e1000g1 phys 1500 up -- --
aggr1 aggr 1500 up —— e1000g0 e1000g1
admin@arc01:~# dladm show-phys
LINK MEDIA STATE SPEED DUPLEX DEVICE
e1000g0 Ethernet up 1000 full e1000g0
e1000g1 Ethernet up 1000 full e1000g1
admin@arc01:~# dladm show—ether
LINE PTYPE STATE AUTO SPEED-DUPLEX PAUSE
e1000g0 current up yes 1G—f bi
e1000g1 current up yes 1G-f bi
admin@arc01:~# dladm show-aggr
LINK POLICY ADDRPOLICY LACPACTIVITY LACPTIMER FLAGS
aggr1 L4 auto active long -----
admin@arc01:~# ifconfig aggr1
aggr1: Flags=1004843{UP,BROADCAST.RUNNING.MULTICAST,DHCP.IPv4} mtu 1500 index 3
inet 192.168.0.200 netmask ffffff00 broadcast 192.168.0.255
ether 68:5:ca:11:19:a6
Routing table shows the following: netstat -r
default 192.168.0.1 UG 2 3 aggr1
arc01 arc01 UH 2 48 lo0
192.168.0.0 192.168.0.200 U 3 1 aggr1
交换机上的配置
interface Port-channel10
description ARC01_LACP
interface GigabitEthernet0/41
description ARC01_LACP
channel-group 10 mode active
interface GigabitEthernet0/42
description ARC01_LACP
channel-group 10 mode active
交换机上的验证
SW01#show interfaces port-channel 10
Port-channel10 is up, line protocol is up (connected)
Hardware is EtherChannel, address is 001f.6d21.14a9 (bia 001f.6d21.14a9)
Description: ARC01_LACP
MTU 1500 bytes, BW 2000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 1000Mb/s, link type is auto, media type is unknown
input flow-control is off, output flow-control is unsupported
Members in this channel: Gi0/41 Gi0/42
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output 00:00:01, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 2000 bits/sec, 3 packets/sec
1766 packets input, 204558 bytes, 0 no buffer
Received 1750 broadcasts (1417 multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 1417 multicast, 0 pause input
0 input packets with dribble condition detected
197210 packets output, 29618326 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out