Debian SAS 未作为 SD 设备连接(另一个可以)

Debian SAS 未作为 SD 设备连接(另一个可以)

我有一台带有 4 个驱动器插槽的 x4100,其中 3 个驱动器属于 RAID 1E。我在 RAID 阵列上安装了 Debian。我使用第 4 个插槽来访问文件存储驱动器。HP 600GB 驱动器成功作为 SD 设备连接。HITACHI 146GB 驱动器无法作为 SD 设备连接。

这是 HP 600GB 的 dmesg,它起作用了

[ 1690.575618] mptsas: ioc0: attaching ssp device: fw_channel 0, fw_id 3, phy 3, sas_addr 0x5000cca0438c25d9
[ 1690.584098] scsi 4:0:5:0: Direct-Access     HP       EG0600FBVFP      HPD9 PQ: 0 ANSI: 5
[ 1690.587021] sd 4:0:5:0: Attached scsi generic sg5 type 0
[ 1690.587955] sd 4:0:5:0: [sdc] 1172123568 512-byte logical blocks: (600 GB/559 GiB)
[ 1690.588213] sd 4:0:5:0: [sdc] Write Protect is off
[ 1690.588215] sd 4:0:5:0: [sdc] Mode Sense: f7 00 10 08
[ 1690.588558] sd 4:0:5:0: [sdc] Write cache: enabled, read cache: enabled, supports DPO and FUA
[ 1690.624829]  sdc: sdc1
[ 1690.627303] sd 4:0:5:0: [sdc] Attached SCSI disk
[ 1786.818313]  end_device-4:5: mptsas: ioc0: removing ssp device: fw_channel 0, fw_id 3, phy 3,sas_addr 0x5000cca0438c25d9
[ 1786.818323]  phy-4:3: mptsas: ioc0: delete phy 3, phy-obj (0x00000000cbdf9139)
[ 1786.818342]  port-4:5: mptsas: ioc0: delete port 5, sas_addr (0x5000cca0438c25d9)
[ 1786.819447] sd 4:0:5:0: [sdc] Synchronizing SCSI cache
[ 1786.866762] scsi target4:0:5: mptsas: ioc0: delete device: fw_channel 0, fw_id 3, phy 3, sas_addr 0x5000cca0438c25d9

这是 HITACHI 146GB 无法正常工作的 dmesg

[ 1843.665188] mptsas: ioc0: attaching ssp device: fw_channel 0, fw_id 3, phy 3, sas_addr 0x5000cca000286b05
[ 1843.678988] scsi 4:0:6:0: Direct-Access     HITACHI  H101414SCSUN146G SA23 PQ: 0 ANSI: 5
[ 1843.686873] scsi 4:0:6:0: Attached scsi generic sg5 type 0
[ 1843.694526] mptbase: ioc0: LogInfo(0x30030501): Originator={IOP}, Code={Invalid Page}, SubCode(0x0501) cb_idx mptbase_reply

由于第二个驱动器没有作为 SD 设备连接,因此我无法使用 lsblk 或 fdisk。

我该如何纠正这个问题?或者这个 SAS 驱动器与 Debian 不兼容?

相关内容