直到昨天,WiFi 都运行正常。突然出现问题 - 我甚至无法在 GUI 顶部菜单上看到“启用无线”选项。
以下是信息:
iwconfig 给了我这个:
eth0 no wireless extensions.
lo no wireless extensions.
ifconfig 给了我这个:
eth0 Link encap:Ethernet HWaddr 28:92:4a:4f:7a:e5
inet addr:192.168.1.241 Bcast:192.168.1.255 Mask:255.255.255.0
inet6 addr: fe80::2a92:4aff:fe4f:7ae5/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:36663 errors:0 dropped:0 overruns:0 frame:0
TX packets:26131 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:50857091 (50.8 MB) TX bytes:2485146 (2.4 MB)
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:862 errors:0 dropped:0 overruns:0 frame:0
TX packets:862 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:69884 (69.8 KB) TX bytes:69884 (69.8 KB)
lspci 给了我这个:
00:00.0 Host bridge: Intel Corporation Ivy Bridge DRAM Controller (rev 09)
00:01.0 PCI bridge: Intel Corporation Ivy Bridge PCI Express Root Port (rev 09)
00:02.0 VGA compatible controller: Intel Corporation Ivy Bridge Graphics Controller (rev 09)
00:14.0 USB controller: Intel Corporation Panther Point USB xHCI Host Controller (rev 04)
00:16.0 Communication controller: Intel Corporation Panther Point MEI Controller #1 (rev 04)
00:1a.0 USB controller: Intel Corporation Panther Point USB Enhanced Host Controller #2 (rev 04)
00:1b.0 Audio device: Intel Corporation Panther Point High Definition Audio Controller (rev 04)
00:1c.0 PCI bridge: Intel Corporation Panther Point PCI Express Root Port 1 (rev c4)
00:1c.1 PCI bridge: Intel Corporation Panther Point PCI Express Root Port 2 (rev c4)
00:1c.2 PCI bridge: Intel Corporation Panther Point PCI Express Root Port 3 (rev c4)
00:1d.0 USB controller: Intel Corporation Panther Point USB Enhanced Host Controller #1 (rev 04)
00:1f.0 ISA bridge: Intel Corporation Panther Point LPC Controller (rev 04)
00:1f.2 SATA controller: Intel Corporation Panther Point 6 port SATA Controller [AHCI mode] (rev 04)
00:1f.3 SMBus: Intel Corporation Panther Point SMBus Controller (rev 04)
01:00.0 VGA compatible controller: Advanced Micro Devices [AMD] nee ATI Thames XT/GL [Radeon HD 7600M Series]
07:00.0 Network controller: Ralink corp. Device 3290
07:00.1 Bluetooth: Ralink corp. Device 3298
08:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8101E/RTL8102E PCI Express Fast Ethernet controller (rev 05)
09:00.0 Unassigned class [ff00]: Realtek Semiconductor Co., Ltd. Device 5229 (rev 01)
ifconfig wlan0 up 给了我这个:
wlan0: ERROR while getting interface flags: No such device
答案1
最近的更新之一是更新的内核版本,称为 linux-image。手动安装驱动程序时,您仅为当前正在运行的内核版本编译它。现在您必须为较新的内核版本构建驱动程序。请打开终端并执行以下操作:
cd Desktop/DPO_RT3290_LinuxSTA_V2600_20120508
...或者您下载并提取最初用于编译驱动程序的文件的位置。
make clean
make
sudo make install
sudo modprobe rt3290sta
您的无线网络现在应该可以正常工作了。每当安装新内核版本时,请重复此过程。