Wifi 不断丢失安全代码并要求进行身份验证。即使我重新编辑连接或在不断出现的弹出窗口中手动输入,现在也无法连接。似乎陷入了循环。多次重新启动都没有成功。结果:peter@peter-laptop:~$ lspci
00:00.0 Host bridge: Advanced Micro Devices, Inc. [AMD/ATI] RS300 Host Bridge (rev 02)
00:01.0 PCI bridge: Advanced Micro Devices, Inc. [AMD/ATI] RS300 AGP Bridge
00:13.0 USB controller: Advanced Micro Devices, Inc. [AMD/ATI] OHCI USB Controller #1 (rev 01)
00:13.1 USB controller: Advanced Micro Devices, Inc. [AMD/ATI] OHCI USB Controller #2 (rev 01)
00:13.2 USB controller: Advanced Micro Devices, Inc. [AMD/ATI] EHCI USB Controller (rev 01)
00:14.0 SMBus: Advanced Micro Devices, Inc. [AMD/ATI] SMBus (rev 1a)
00:14.1 IDE interface: Advanced Micro Devices, Inc. [AMD/ATI] Dual Channel Bus Master PCI IDE Controller
00:14.3 ISA bridge: Advanced Micro Devices, Inc. [AMD/ATI] Device 434c
00:14.4 PCI bridge: Advanced Micro Devices, Inc. [AMD/ATI] IXP200 3COM 3C920B Ethernet Controller
00:14.5 Multimedia audio controller: Advanced Micro Devices, Inc. [AMD/ATI] IXP150 AC'97 Audio Controller (rev 01)
00:14.6 Modem: Advanced Micro Devices, Inc. [AMD/ATI] IXP AC'97 Modem (rev 01)
01:05.0 VGA compatible controller: Advanced Micro Devices, Inc. [AMD/ATI] RV350/M10 [Mobility Radeon 9600 PRO Turbo]
02:00.0 FireWire (IEEE 1394): VIA Technologies, Inc. VT6306/7/8 [Fire II(M)] IEEE 1394 OHCI Controller (rev 80)
02:02.0 Ethernet controller: Qualcomm Atheros AR5212/AR5213 Wireless Network Adapter (rev 01)
02:03.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8139/8139C/8139C+ (rev 10)
02:04.0 CardBus bridge: ENE Technology Inc CB-710/2/4 Cardbus Controller
02:04.1 FLASH memory: ENE Technology Inc ENE PCI Memory Stick Card Reader Controller
02:04.2 SD Host controller: ENE Technology Inc ENE PCI Secure Digital Card Reader Controller
02:04.3 FLASH memory: ENE Technology Inc FLASH memory: ENE Technology Inc:
peter@peter-laptop:~$ ifconfig -a
eth0 Link encap:Ethernet HWaddr 00:0f:b0:3a:19:54
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
Interrupt:19 Base address:0xa000
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:900 errors:0 dropped:0 overruns:0 frame:0
TX packets:900 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:66460 (66.4 KB) TX bytes:66460 (66.4 KB)
wlan0 Link encap:Ethernet HWaddr 00:11:f5:29:f1:38
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
peter@peter-laptop:~$ sudo iwconfig
[sudo] password for peter:
lo no wireless extensions.
wlan0 IEEE 802.11bg ESSID:off/any
Mode:Managed Access Point: Not-Associated Tx-Power=20 dBm
Retry long limit:7 RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
eth0 no wireless extensions.
答案1
我遇到了类似的问题,我通过在文件夹等处创建一个名为 resolv.conf 的文件来解决。之后它开始连接。
sudo gedit /etc/resolv.conf
该文件包含名称服务器:
名称服务器 127.0.1.1