为什么 USB 驱动器自动挂载三次?

为什么 USB 驱动器自动挂载三次?

我正在与 Mate 一起运行 Ubuntu 16.04 LTS。

当我插入 USB 笔式驱动器时,系统似乎尝试安装该驱动器次。我打开了三个文件夹,并收到两条错误消息“无法挂载 129 MB 卷设备 /dev/sdd1 已挂载在 `/media/paul/2323-66A0'。”(我猜第一次挂载尝试是成功的,因此最初没有错误消息)。

什么过程触发了这些自动挂载?它在哪里配置?

除了这个问题之外,驱动器看起来很好:我可以像往常一样移动文件夹并卸载。

根据以下评论进行更新:

[496:~]$ lsblk
NAME   MAJ:MIN RM   SIZE RO TYPE MOUNTPOINT
sda      8:0    0 465.8G  0 disk 
├─sda1   8:1    0 964.8M  0 part 
├─sda2   8:2    0 455.1G  0 part /mnt/backup
└─sda3   8:3    0   9.8G  0 part [SWAP]
sdb      8:16   0  55.9G  0 disk 
└─sdb1   8:17   0  55.9G  0 part /
sdc      8:32   0   1.8T  0 disk 
├─sdc1   8:33   0 931.5G  0 part /home
└─sdc2   8:34   0 931.5G  0 part 
sdd      8:48   0 123.5M  0 disk 
└─sdd1   8:49   0 123.5M  0 part /media/paul/2323-66A0
loop0    7:0    0  83.7M  1 loop /snap/core/3440
loop1    7:1    0  83.8M  1 loop /snap/core/3604
loop2    7:2    0  83.1M  1 loop /snap/core/3247
loop3    7:3    0    83M  1 loop

[496:~]$ sudo parted -l
Model: ATA ST3500630A (scsi)
Disk /dev/sda: 500GB
Sector size (logical/physical): 512B/512B
Partition Table: msdos
Disk Flags: 

Number  Start   End     Size    Type     File system     Flags
 1      32.3kB  1012MB  1012MB  primary
 2      1012MB  490GB   489GB   primary  reiserfs
 3      490GB   500GB   10.5GB  primary  linux-swap(v1)



Model: ATA OCZ-VERTEX2 (scsi)
Disk /dev/sdb: 60.0GB
Sector size (logical/physical): 512B/512B
Partition Table: msdos
Disk Flags: 

Number  Start   End     Size    Type     File system  Flags
 1      1049kB  60.0GB  60.0GB  primary  ext4         boot


Model: ATA ST2000DX002-2DV1 (scsi)
Disk /dev/sdc: 2000GB
Sector size (logical/physical): 512B/4096B
Partition Table: msdos
Disk Flags: 

Number  Start   End     Size    Type     File system  Flags
 1      1049kB  1000GB  1000GB  primary  ext4
 2      1000GB  2000GB  1000GB  primary  ext4


Model: USB Flash Disk (scsi)
Disk /dev/sdd: 129MB
Sector size (logical/physical): 512B/512B
Partition Table: msdos
Disk Flags: 


Number  Start  End    Size   Type     File system  Flags
 1      512B   129MB  129MB  primary  fat32

USB 驱动器当然/dev/sdd只有 1 个分区。

journalctl --follow给了:

Dec 11 17:41:26 larkfield kernel: usb 1-2: new high-speed USB device number 24 using ehci-pci
Dec 11 17:41:26 larkfield kernel: usb 1-2: New USB device found, idVendor=090c, idProduct=1000
Dec 11 17:41:26 larkfield kernel: usb 1-2: New USB device strings: Mfr=1, Product=2, SerialNumber=3
Dec 11 17:41:26 larkfield kernel: usb 1-2: Product: USB DISK
Dec 11 17:41:26 larkfield kernel: usb 1-2: Manufacturer: SMI Corporation
Dec 11 17:41:26 larkfield kernel: usb 1-2: SerialNumber: AA04012707524
Dec 11 17:41:26 larkfield kernel: usb-storage 1-2:1.0: USB Mass Storage device detected
Dec 11 17:41:26 larkfield kernel: scsi host31: usb-storage 1-2:1.0
Dec 11 17:41:26 larkfield mtp-probe[5367]: checking bus 1, device 24: "/sys/devices/pci0000:00/0000:00:1a.7/usb1/1-2"
Dec 11 17:41:26 larkfield mtp-probe[5367]: bus: 1, device: 24 was not an MTP device
Dec 11 17:41:27 larkfield kernel: scsi 31:0:0:0: Direct-Access     USB      Flash Disk       1100 PQ: 0 ANSI: 0 CCS
Dec 11 17:41:27 larkfield kernel: sd 31:0:0:0: Attached scsi generic sg3 type 0
Dec 11 17:41:27 larkfield kernel: sd 31:0:0:0: [sdd] 252928 512-byte logical blocks: (129 MB/124 MiB)
Dec 11 17:41:27 larkfield kernel: sd 31:0:0:0: [sdd] Write Protect is off
Dec 11 17:41:27 larkfield kernel: sd 31:0:0:0: [sdd] Mode Sense: 43 00 00 00
Dec 11 17:41:27 larkfield kernel: sd 31:0:0:0: [sdd] No Caching mode page found
Dec 11 17:41:27 larkfield kernel: sd 31:0:0:0: [sdd] Assuming drive cache: write through
Dec 11 17:41:27 larkfield kernel:  sdd: sdd1
Dec 11 17:41:27 larkfield kernel: sd 31:0:0:0: [sdd] Attached SCSI disk
Dec 11 17:41:28 larkfield udisksd[2699]: Mounted /dev/sdd1 at /media/paul/2323-66A0 on behalf of uid 1000

这看起来并不太不寻常。接下来是:

Dec 11 17:41:28 larkfield gvfsd[2634]: ** (process:2743): WARNING **: send_infos_cb: No such interface 'org.gtk.vfs.Enumerator' on object at path /org/gtk/vfs/client/enumerator/2350 (g-dbus-error-quark, 19)

大约 45 次,确实如此(但可能不相关)。

相关内容