我无法在 HP Notebook 15 中的 Ubuntu 16.04 中连接宽带 Wifi,但我可以将其与 Windows 和 Android 手机连接。
以下是有关我的 Wifi 驱动程序和硬件的信息。
串行通信
00:00.0 Host bridge: Intel Corporation Broadwell-U Host Bridge -OPI (rev 09)
00:02.0 VGA compatible controller: Intel Corporation HD Graphics 5500 (rev 09)
00:03.0 Audio device: Intel Corporation Broadwell-U Audio Controller (rev 09)
00:04.0 Signal processing controller: Intel Corporation Broadwell-U Processor Thermal Subsystem (rev 09)
00:14.0 USB controller: Intel Corporation Wildcat Point-LP USB xHCI Controller (rev 03)
00:16.0 Communication controller: Intel Corporation Wildcat Point-LP MEI Controller #1 (rev 03)
00:1b.0 Audio device: Intel Corporation Wildcat Point-LP High Definition Audio Controller (rev 03)
00:1c.0 PCI bridge: Intel Corporation Wildcat Point-LP PCI Express Root Port #1 (rev e3)
00:1c.2 PCI bridge: Intel Corporation Wildcat Point-LP PCI Express Root Port #3 (rev e3)
00:1c.5 PCI bridge: Intel Corporation Wildcat Point-LP PCI Express Root Port #6 (rev e3)
00:1f.0 ISA bridge: Intel Corporation Wildcat Point-LP LPC Controller (rev 03)
00:1f.2 SATA controller: Intel Corporation Wildcat Point-LP SATA Controller [AHCI Mode] (rev 03)
00:1f.3 SMBus: Intel Corporation Wildcat Point-LP SMBus Controller (rev 03)
00:1f.6 Signal processing controller: Intel Corporation Wildcat Point-LP Thermal Management Controller (rev 03)
07:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL810xE PCI
Express Fast Ethernet controller (rev 07)
0d:00.0 Network controller: Realtek Semiconductor Co., Ltd. RTL8723BE PCIe
Wireless Network Adapter
rfkill 列出全部
0: hci0: Bluetooth
Soft blocked: no
Hard blocked: no
1: phy0: Wireless LAN
Soft blocked: no
Hard blocked: no
uname -r
4.13.0-37-generic
nmcli dev wifi 列表
SSID MODE CHAN RATE SIGNAL BARS SECURITY
vivek_m Infra 1 54 Mbit/s 62 ▂▄▆_ WPA2
有时
nmcli dev wifi 列表
SSID MODE CHAN RATE SIGNAL BARS SECURITY
vivek_m Infra 1 54 Mbit/s 62 ▂▄▆_ WPA2
pg 1 Infra 6 54 Mbit/s 24 ▂___ WPA2
目前我无法连接 pg1,而其他 pg2 没有显示在列表中,尽管我同时使用 pg2 连接到 android,
有时 pg2 连接在 wifi 列表中可用,但在命令列表中不可用,请检查屏幕截图,它在灯光棚中的 wifi 列表中列出,当我单击它时,它给了我一个错误:
(7) The access point /org/freedesktop/NetworkManager/AccessPoint/109 was
not in the scan list.
sudo lshw -c 网络
network
description: Ethernet interface
product: RTL810xE PCI Express Fast Ethernet controller
vendor: Realtek Semiconductor Co., Ltd.
physical id: 0
bus info: pci@0000:07:00.0
logical name: enp7s0
version: 07
serial: 70:5a:0f:97:e8:cc
size: 10Mbit/s
capacity: 100Mbit/s
width: 64 bits
clock: 33MHz
capabilities: pm msi pciexpress msix vpd bus_master cap_list ethernet physical tp mii 10bt 10bt-fd 100bt 100bt-fd autonegotiation
configuration: autonegotiation=on broadcast=yes driver=r8169 driverversion=2.3LK-NAPI duplex=half firmware=rtl8106e-1_0.0.1 06/29/12 latency=0 link=no multicast=yes port=MII speed=10Mbit/s
resources: irq:43 ioport:4000(size=256) memory:c5000000-c5000fff memory:c5100000-c5103fff
-network
description: Wireless interface
product: RTL8723BE PCIe Wireless Network Adapter
vendor: Realtek Semiconductor Co., Ltd.
physical id: 0
bus info: pci@0000:0d:00.0
logical name: wlp13s0
version: 00
serial: 44:1c:a8:73:7d:25
width: 64 bits
clock: 33MHz
capabilities: pm msi pciexpress bus_master cap_list ethernet physical wireless
configuration: broadcast=yes driver=rtl8723be driverversion=4.13.0-37-generic firmware=N/A ip=192.168.43.204 latency=0 link=yes multicast=yes wireless=IEEE 802.11
resources: irq:16 ioport:3000(size=256) memory:c3000000-c3003fff
系统配置
enp7s0 no wireless extensions.
lo no wireless extensions.
wlp13s0 IEEE 802.11 ESSID:"vivek_m"
Mode:Managed Frequency:2.412 GHz Access Point: CC:61:E5:42:7B:63
Bit Rate=72.2 Mb/s Tx-Power=20 dBm
Retry short limit:7 RTS thr=2347 B Fragment thr:off
Power Management:on
Link Quality=52/70 Signal level=-58 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:1701 Missed beacon:0
如果这里还有其他问题需要回答,请告诉我,并帮助我连接这个 Wifi。
谢谢。
答案1
首先删除您所做的设置。
sudo rm /etc/modprobe.d/rtl8723be.conf
如果您没有此文件,则没有任何问题。
然后安装好驱动程序
sudo add-apt-repository ppa:hanipouspilot/rtlwifi
sudo apt-get update
sudo apt-get install rtlwifi-new-dkms
重启并享受
如果仍然有问题(信号弱),您可能需要添加一个选项:
echo "options rtl8723be ant_sel=2" | sudo tee /etc/modprobe.d/rtl8723be.conf
或者
echo "options rtl8723be ant_sel=1" | sudo tee /etc/modprobe.d/rtl8723be.conf