☰

设置论文几何

tag-icon • tag-icon margins memoir geometry thesis
设置论文几何

我正在撰写我的硕士论文，我使用的模板具有以下几何形状：

   %----------------------------------------------------------------------------------------
%   MARGIN SETTINGS
%----------------------------------------------------------------------------------------

\geometry{
    paper=a4paper, % Change to letterpaper for US letter
    inner=2.5cm, % Inner margin
    outer=3.8cm, % Outer margin
    bindingoffset=2cm, % Binding offset
    top=1.5cm, % Top margin
    bottom=1.5cm, % Bottom margin
    %showframe,% show how the type block is set on the page
}

结果非常窄，我认为应该更宽一些。我找到了另一个使用类回忆录和以下设置的不错的模板：

\setlrmarginsandblock{37.125mm}{*}{0.9} % The first bracket specifies the spine margin, the second the edge margin and the third the ratio of the spine to the edge. Only one or two values are required and the remaining one(s) can be a star (*) to specify it is not needed. By default the edge margin is 10% smaller and 
\setulmarginsandblock{37.125mm}{*}{*} % The first bracket specifies the upper margin, the second the lower margin and the third the ratio of the upper to the lower. Only one or two values are required and the remaining one(s) can be a star (*) to specify it is not needed.
\setmarginnotes{17pt}{51pt}{\onelineskip} % The size of marginal notes, the three values in curly brackets are \marginparsep, \marginparwidth and \marginparpush
\setheadfoot{\onelineskip}{2\onelineskip} % Sets the space available for the header and footer
\setheaderspaces{*}{2\onelineskip}{*} % Sets the spacing above and below the header
\setlength{\trimtop}{0pt} % Sets the spacing above the trimmed area, i.e. moved the trimmed area down the page if positive

% Comment the two lines below to reverse the position of the trimmed content on the stock paper, i.e. odd pages will have content on the right side instead of the left and even pages will have content on the left side instead of the right
\setlength{\trimedge}{\stockwidth}
\addtolength{\trimedge}{-\paperwidth}

\checkandfixthelayout % Makes sure your specifications are correct and implements them in the document

问题是我不知道如何将边距设置为与这些相等，因为我正在加载包含整个结构和设置的 .cls 文件，而不是类回忆录。您知道如何更改几何设置以获得与上述代码相同的结果吗？

答案1

你得到的结果memoir与

\geometry{
  inner=37.125mm,
  outer=33.4125mm,
  top=37.125mm,
  bottom=37.125mm,
  heightrounded,
  marginparwidth=51pt,
  marginparsep=17pt,
  headsep=24pt,
}

相关内容