这些问题看起来很相似，但是却不起作用：
这是我的 RAID 配置，来自 tw_cli /c0 show all
/c1 Driver Version = 2.26.02.014
/c0 Model = 9650SE-4LPML
/c0 Available Memory = 224MB
/c0 Firmware Version = FE9X 4.10.00.024
/c0 Bios Version = BE9X 4.08.00.004
/c0 Boot Loader Version = BL9X 3.08.00.001
/c0 Serial Number = L326009A9151022
/c0 PCB Version = Rev 035
/c0 PCHIP Version = 2.00
/c0 ACHIP Version = 1.90
/c0 Number of Ports = 4
/c0 Number of Drives = 4
/c0 Number of Units = 1
/c0 Total Optimal Units = 1
/c0 Not Optimal Units = 0
/c0 JBOD Export Policy = off
/c0 Disk Spinup Policy = 1
/c0 Spinup Stagger Time Policy (sec) = 1
/c0 Auto-Carving Policy = off
/c0 Auto-Carving Size = 2048 GB
/c0 Auto-Rebuild Policy = on
/c0 Rebuild Mode = Adaptive
/c0 Rebuild Rate = 1
/c0 Verify Mode = Adaptive
/c0 Verify Rate = 1
/c0 Controller Bus Type = PCIe
/c0 Controller Bus Width = 4 lanes
/c0 Controller Bus Speed = 2.5 Gbps/lane
Unit UnitType Status %RCmpl %V/I/M Stripe Size(GB) Cache AVrfy
------------------------------------------------------------------------------
u0 RAID-5 OK - - 256K 8381.87 RiW ON
VPort Status Unit Size Type Phy Encl-Slot Model
------------------------------------------------------------------------------
p0 OK u0 5.45 TB SATA 0 - WDC WD60EFRX-68MYMN1
p1 OK u0 5.45 TB SATA 1 - WDC WD60EFRX-68MYMN1
p2 OK u0 5.45 TB SATA 2 - WDC WD60EFRX-68MYMN1
p3 OK u0 5.45 TB SATA 3 - WDC WD60EFRX-68MYMN1
无论是使用 tw_cli 还是 3dm2，我都无法使用更大的磁盘。我尝试过：
# tw_cli /c0/u0 migrate type=raid5 disk=0-3
Error: (CLI:008) Invalid ID specified. Found a specified ID already in use.
使用 3dm2，我选择了设备，点击了“迁移设备”，它显示：没有可用于迁移的驱动器
我错过了什么？