docker-engine 安装后无法检测到 wifi

docker-engine 安装后无法检测到 wifi

我正在全新安装 16.10,并尝试在其上安装 Docker。我添加了 PPA,更新了 apt,然后启动了:

sudo apt install docker-engine

它运行完美。

现在,当我重新启动时,我的 Wifi 无法被检测到!看来 docker 接口与我现有的网络接口产生了冲突。它甚至将其从 ifconfig 中删除。

编辑:这是之前/之后的一些命令输出:

$ cat /etc/network/interfaces
# interfaces(5) file used by ifup(8) and ifdown(8)
auto lo
iface lo inet loopback

(前后相同)

$ ifconfig -a

前:

lo: flags=73<UP,LOOPBACK,RUNNING>  mtu 65536
        inet 127.0.0.1  netmask 255.0.0.0
        inet6 ::1  prefixlen 128  scopeid 0x10<host>
        loop  txqueuelen 1  (Boucle locale)
        RX packets 62183  bytes 3862625 (3.8 MB)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 62183  bytes 3862625 (3.8 MB)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0

wlp58s0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST>  mtu 1500
            inet 192.168.0.18  netmask 255.255.255.0  broadcast 192.168.0.255
            inet6 fe80::46f0:8dad:aded:afbf  prefixlen 64  scopeid 0x20<link>
            ether 9c:b6:d0:d4:83:ab  txqueuelen 1000  (Ethernet)
            RX packets 74434  bytes 83729393 (83.7 MB)
            RX errors 0  dropped 0  overruns 0  frame 0
            TX packets 56425  bytes 9260378 (9.2 MB)
            TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0

后:

docker0: flags=4099<UP,BROADCAST,MULTICAST>  mtu 1500
        inet 172.17.0.1  netmask 255.255.0.0  broadcast 0.0.0.0
        ether 02:42:48:c6:4c:bb  txqueuelen 0  (Ethernet)
        RX packets 0  bytes 0 (0.0 B)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 0  bytes 0 (0.0 B)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0

lo: flags=73<UP,LOOPBACK,RUNNING>  mtu 65536
        inet 127.0.0.1  netmask 255.0.0.0
        inet6 ::1  prefixlen 128  scopeid 0x10<host>
        loop  txqueuelen 1  (Boucle locale)
        RX packets 3059  bytes 199733 (199.7 KB)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 3059  bytes 199733 (199.7 KB)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0

lspci -nnk | grep -A2 Network

前:

3a:00.0 Network controller [0280]: Qualcomm Atheros QCA6174 802.11ac Wireless Network Adapter [168c:003e] (rev 32)
    Subsystem: Bigfoot Networks, Inc. QCA6174 802.11ac Wireless Network Adapter [1a56:1535]
    Kernel driver in use: ath10k_pci
    Kernel modules: ath10k_pci

后:

3a:00.0 Network controller [0280]: Qualcomm Atheros QCA6174 802.11ac Wireless Network Adapter [168c:003e] (rev 32)
    Subsystem: Bigfoot Networks, Inc. QCA6174 802.11ac Wireless Network Adapter [1a56:1535]
    Kernel modules: ath10k_pci
3b:00.0 Unassigned class [ff00]: Realtek Semiconductor Co., Ltd. RTS525A PCI Express Card Reader [10ec:525a] (rev 01)

ip a

前:

1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1
    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
    inet 127.0.0.1/8 scope host lo
       valid_lft forever preferred_lft forever
    inet6 ::1/128 scope host 
       valid_lft forever preferred_lft forever
2: wlp58s0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP group default qlen 1000
    link/ether 9c:b6:d0:d4:83:ab brd ff:ff:ff:ff:ff:ff
    inet 192.168.0.18/24 brd 192.168.0.255 scope global dynamic wlp58s0
       valid_lft 863729sec preferred_lft 863729sec
    inet6 fe80::46f0:8dad:aded:afbf/64 scope link 
       valid_lft forever preferred_lft forever

后:

1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1
    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
    inet 127.0.0.1/8 scope host lo
       valid_lft forever preferred_lft forever
    inet6 ::1/128 scope host 
       valid_lft forever preferred_lft forever
2: docker0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc noqueue state DOWN group default 
    link/ether 02:42:48:c6:4c:bb brd ff:ff:ff:ff:ff:ff
    inet 172.17.0.1/16 scope global docker0
       valid_lft forever preferred_lft forever

ifconfig -a(在安装 docker-engine 之后,重启之前):

docker0: flags=4099<UP,BROADCAST,MULTICAST>  mtu 1500
        inet 172.17.0.1  netmask 255.255.0.0  broadcast 0.0.0.0
        ether 02:42:bc:88:15:f6  txqueuelen 0  (Ethernet)
        RX packets 0  bytes 0 (0.0 B)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 0  bytes 0 (0.0 B)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0

lo: flags=73<UP,LOOPBACK,RUNNING>  mtu 65536
        inet 127.0.0.1  netmask 255.0.0.0
        inet6 ::1  prefixlen 128  scopeid 0x10<host>
        loop  txqueuelen 1  (Boucle locale)
        RX packets 70992  bytes 4402758 (4.4 MB)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 70992  bytes 4402758 (4.4 MB)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0

wlp58s0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST>  mtu 1500
        inet 192.168.0.18  netmask 255.255.255.0  broadcast 192.168.0.255
        inet6 fe80::46f0:8dad:aded:afbf  prefixlen 64  scopeid 0x20<link>
        ether 9c:b6:d0:d4:83:ab  txqueuelen 1000  (Ethernet)
        RX packets 93928  bytes 110058973 (110.0 MB)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 68156  bytes 10649275 (10.6 MB)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0

以下命令也未执行任何操作:

sudo systemctl restart network-manager

我正在使用一台没有以太网连接、只有 Wifi 的笔记本电脑。

sources.list中添加的PPA是:

deb https://apt.dockerproject.org/repo ubuntu-xenial main

答案1

研究表明,这可能与这个错误。如果是这样,解决方法是修改/etc/NetworkManager/NetworkManager.conf

[main]
plugins=ifupdown,keyfile

[ifupdown]
managed=false

[keyfile]
unmanaged-devices=interface-name:docker0

这将使得 NetworkManager 忽略 docker 适配器。

资料来源:

https://github.com/moby/moby/issues/30343

https://bugs.launchpad.net/ubuntu/+source/network-manager/+bug/1458322

相关内容