我有一个蓝牙扬声器，可以正常工作。但音频效果很差，跳音很多次：
Aug 28 21:02:25 test pulseaudio[2537]: [bluetooth] module-bluez5-device.c: Skipping 309976 us (= 54676 bytes) in audio stream
Aug 28 21:02:25 test pulseaudio[2537]: [bluetooth] module-bluez5-device.c: Skipping 84982 us (= 14988 bytes) in audio stream
Aug 28 21:02:26 test pulseaudio[2537]: [bluetooth] module-bluez5-device.c: Skipping 208448 us (= 36768 bytes) in audio stream
由于 wifi 和 BT 是一起的，所以考虑暂时关闭 wifi 连接：宾果！禁用 wifi 后，蓝牙音频听起来很完美。
lucas@test:~$ sudo lshw -c Network
*-network
description: Wireless interface
product: BCM43142 802.11b/g/n
vendor: Broadcom Corporation
physical id: 0
bus info: pci@0000:08:00.0
logical name: wlo1
version: 01
serial: d8:5d:e2:cc:38:5d
width: 64 bits
clock: 33MHz
capabilities: pm msi pciexpress bus_master cap_list ethernet physical wireless
configuration: broadcast=yes driver=wl0 driverversion=6.30.223.271 (r587334) ip=192.168.0.2 latency=0 multicast=yes wireless=IEEE 802.11
resources: irq:18 memory:b5500000-b5507fff
lucas@test:~$ sudo lsusb -v | grep Blue
Bus 001 Device 005: ID 0a5c:216c Broadcom Corp. BCM43142A0 Bluetooth Device
idProduct 0x216c BCM43142A0 Bluetooth Device
我在用着：
lucas@test:~$ lsb_release -a
No LSB modules are available.
Distributor ID: Ubuntu
Description: Ubuntu 16.04.3 LTS
Release: 16.04
Codename: xenial
lucas@test:~$ uname -a
Linux test 4.10.0-32-generic #36~16.04.1-Ubuntu SMP Wed Aug 9 09:19:02 UTC 2017 x86_64 x86_64 x86_64 GNU/Linux
有没有办法同时激活 BT+wifi 而不会出现音频不连贯的情况？可能是由于信道干扰造成的？
谢谢！