无线驱动程序

无线驱动程序

我的笔记本电脑的结果如下。如何安装无线驱动程序和显卡?

$ lspci
00:00.0 Host bridge: Intel Corporation 2nd Generation Core Processor Family DRAM Controller (rev 09)
00:02.0 VGA compatible controller: Intel Corporation 2nd Generation Core Processor Family Integrated Graphics Controller (rev 09)
00:14.0 USB controller: Intel Corporation Panther Point USB xHCI Host Controller (rev 04)
00:16.0 Communication controller: Intel Corporation Panther Point MEI Controller #1 (rev 04)
00:1a.0 USB controller: Intel Corporation Panther Point USB Enhanced Host Controller #2 (rev 04)
00:1b.0 Audio device: Intel Corporation Panther Point High Definition Audio Controller (rev 04)
00:1c.0 PCI bridge: Intel Corporation Panther Point PCI Express Root Port 1 (rev c4)
00:1c.1 PCI bridge: Intel Corporation Panther Point PCI Express Root Port 2 (rev c4)
00:1c.3 PCI bridge: Intel Corporation Panther Point PCI Express Root Port 4 (rev c4)
00:1d.0 USB controller: Intel Corporation Panther Point USB Enhanced Host Controller #1 (rev 04)
00:1f.0 ISA bridge: Intel Corporation Panther Point LPC Controller (rev 04)
00:1f.2 SATA controller: Intel Corporation Panther Point 6 port SATA Controller [AHCI mode] (rev 04)
00:1f.3 SMBus: Intel Corporation Panther Point SMBus Controller (rev 04)
02:00.0 Network controller: Broadcom Corporation Device 4365 (rev 01)
03:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8111/8168B PCI Express Gigabit Ethernet controller (rev 07)

$ sudo lshw -c network
  *-network UNCLAIMED     
       description: Network controller
       product: Broadcom Corporation
       vendor: Broadcom Corporation
       physical id: 0
       bus info: pci@0000:02:00.0
       version: 01
       width: 64 bits
       clock: 33MHz
       capabilities: pm msi pciexpress bus_master cap_list
       configuration: latency=0
       resources: memory:f0500000-f0507fff
  *-network
       description: Ethernet interface
       product: RTL8111/8168B PCI Express Gigabit Ethernet controller
       vendor: Realtek Semiconductor Co., Ltd.
       physical id: 0
       bus info: pci@0000:03:00.0
       logical name: eth0
       version: 07
       serial: 3c:97:0e:85:c0:0d
       size: 100Mbit/s
       capacity: 1Gbit/s
       width: 64 bits
       clock: 33MHz
       capabilities: pm msi pciexpress msix vpd bus_master cap_list ethernet physical tp mii 10bt 10bt-fd 100bt 100bt-fd 1000bt 1000bt-fd autonegotiation
       configuration: autonegotiation=on broadcast=yes driver=r8169 driverversion=2.3LK-NAPI duplex=full firmware=rtl8168e-3_0.0.4 03/27/12 ip=172.16.96.36 latency=0 link=yes multicast=yes port=MII speed=100Mbit/s
       resources: irq:43 ioport:2000(size=256) memory:f0404000-f0404fff memory:f0400000-f0403fff

$ rfkill list all
0: tpacpi_bluetooth_sw: Bluetooth
    Soft blocked: no
    Hard blocked: no

答案1

根据您的 lspci 输出,我认为您需要安装的额外驱动程序是用于无线网卡的驱动程序:

02:00.0 网络控制器:Broadcom Corporation 设备 4365(修订版 01)

(只有当它根本不起作用时才需要它,否则您就不需要它。)

请使用以太网端口连接到互联网(您必须从互联网上下载专有驱动程序)并打开仪表板,搜索“驱动程序,您将看到一个工具: 在此处输入图片描述 选择 Broadcom 无线驱动程序,按“应用更改” 在此处输入图片描述

这是 14.04 中的一个例子,但它也可以适用于 12.04。

您的显卡是:

00:02.0 VGA 兼容控制器:英特尔公司第二代酷睿处理器系列集成图形控制器(rev 09)

它已经受支持。如果您认为您的系统有另一块显卡,但未检测到,则必须检查 BIOS 设置和 dmesg 输出。

相关内容